Доброго времени суток. Всех с прошедшим праздником. Наконец дошли руки снова до своего премиального
аппарата. Запись с разных флешек в режиме авто , не пошла. Лог загрузки прилагаю:
HW BootLoader APP init!
CH455 panel init OK!
g_boot_type = 0
flash init OK,flash size is:0!
boot_type = 17
boot_code = 0x4865480c
MG_Setup_CRC_Table finish.
check_program finish.
CPU Main code, 81449000, 2ca1cd, 1fe0100, 2ca1cd.
SEE Main code, 81714000, e5024, 6f90101, e5024.
expand see main code, ziped len: 0x79f314f6
expand see, unzip_length = 0x2e63a4
run see, see_entry = 0x817fa000!
expand cpu main code, ziped len: 0xfdc3dcac
expand main, unzip_length = 0xb46eb8
4!
success!
MC: APP init ok
<< SDK4.0ba.4.0_20101217 >>
Libcore version 13.7.0@SDK4.0ga.13.7_20150114(gcc version 3.4.4 mipssde-6.06.01-20070420)(xuehui.li@ 2015年07月24日 9:28:26)
Application version 1.0.0@SDK4.0ga.13.7_20150114byD32HYJ
test r836 tuner i2c --> 1
--->> tuner type : 836
board_frontend_init : 463
board_frontend_init : 521
init_gma_hw_buffer : line 106 test size of tablebase 1 800 2 400
eth_mac_attach INIT error!
rf read result = 0, data[0] = 0x69, data[5] = 0x11
rf read result = 0, data[0] = 0x69, data[5] = 0x11
rf read result = 0, data[0] = 0x69, data[5] = 0x11
rf read result = 0, data[0] = 0x69, data[5] = 0x11
rf read result = 0, data[0] = 0x69, data[5] = 0x11
rf read result = 0, data[0] = 0x69, data[5] = 0x11
rf read result = 0, data[0] = 0x69, data[5] = 0x11
rf read result = 0, data[0] = 0x69, data[5] = 0x11
rf read result = 0, data[0] = 0x69, data[5] = 0x11
rf read result = 0, data[0] = 0x69, data[5] = 0x11
board_frontend_init : 521
net device don't attach!
hs_config_init hs config data total size [130048]
hs_config_init key db offset[0] size[65536].
hs_config_init hs_control offset[10000] size[16016].
hs_config_init hs_control priority size[6004] use for smap size [4228].
versin 10 , size 16004 crc 2c5e | calcrc 2c5e
init ok 1 very crc [2c5e | 2c5e]
================control data write =============crc[2c5e] size[16004]
STB ID : 00 00 00 00 00 00 00
STB MAC ADDR : 00 00 00 00 00 00
_RD_DEBUG_ = 0, if == 1, dont release
cold boot
(-9-15-12 )
libnet_init start!
netif:lo is default
libnet_init error!
ali play 1.0 $$$
Там где размер флеш - 0!,должен быть размер памяти? Флеш проверил, впаял в тв Декс, все пошло на ура. Но гдето есть подвох.
Добавлено: 26 Февраль 2019, 20:18:05
А ЕЩЕ STB ID - нолики, да и STB MAC ADDR тоже нули .